This is a carrier for an M.2 storage drive. It installs into the following BOSS S2 module.
Part Category: Storage
-
BOSS S2 Signal Cable 09GYJK
Signal cable that runs from the BOSS S2 module to the motherboard. Below you can see it coming out of the card along with the following power cable.
-
BOSS-S2 Module 0FGNRW
BOSS-S2 module. This module attaches to riser 1 on the R750 and adds support for dual redundant M.2 drives. 2 cables attach from the module to the motherboard. Below you can see it installed on riser 1:
-
R750 24-Bay Front Controller SAS Cable 05407J
This is a short cable that runs from a front RAID/HBA controller to the motherboard. See this part for the other cable required to configure a front HBA or RAID controller on the R750 24 bay server.
-
R750 24-Bay Front Controller SAS Cable 0N57F2
This is an internal Slim-SAS cable designed for the Dell PowerEdge R750 24 bay server. It’s a short run of cable to connect a front RAID/HBA controller to the backplane.
One end of the cable is labeled FCTRL_B. This end plugs into your RAID or HBA controller.
The other end is labeled EXP_DST_SB1 (Expander Destination Sideband 1) and plugs into the backplane.