One set of HP NVME signal cables. These cables were pulled from an HP DL 360 G10 Plus server. They enable 4 bays with PCIe connectivity. One end of the cables plugs into ports 3 and 4 on the backplane and the other side connects to the motherboard on ports 1A and 2A.
Part Category: Storage
-
BOSS S2 M.2 Carrier 0HM7F6
This is a carrier for an M.2 storage drive. It installs into the following BOSS S2 module.
-
BOSS S2 Signal Cable 09GYJK
Signal cable that runs from the BOSS S2 module to the motherboard. Below you can see it coming out of the card along with the following power cable.
-
BOSS-S2 Module 0FGNRW
BOSS-S2 module. This module attaches to riser 1 on the R750 and adds support for dual redundant M.2 drives. 2 cables attach from the module to the motherboard. Below you can see it installed on riser 1:
-
R750 24-Bay Front Controller SAS Cable 05407J
This is a short cable that runs from a front RAID/HBA controller to the motherboard. See this part for the other cable required to configure a front HBA or RAID controller on the R750 24 bay server.