This is one set of Mini SAS cables that connect the backplane to the SAS Expander on an HP DL 380 G10 server. The cable plugs into ports 1 and 2 in BAY 1. It routes along the left side of the server chassis and then plugs into ports 3 and 4 on the SAS expander installed in riser 1.
Please read the following guide for installation instructions and more pictures.
This cable attaches the rear flex to the backplane (Port A2) on the R730xd 12 Bay chassis. This cable will NOT work with the 24 bay chassis. Due to differences in backplane design the 24 bay uses a different SAS cable. However, the signal and power cable remain the same.
This is a short signal cable that goes from the rear flex bay to the motherboard on the R730xd chassis.
This is the PERC Cable for the Dell PowerEdge R430 4 bay chassis. It also has 2 SATA connectors for the optional internal drive tray.
This cable connects the backplane to one of Dells mini mono RAID controllers on the R730xd 12 Bay chassis.
Plug one end into the backplane and then route the cable through the channel located on the right side of the server. The other end labeled PERC will terminate near the middle right side of the chassis. You will see the slot just before riser 1. Screw it down to a compatible DELL mini RAID controller.