This is the standard fan that installs into the fan assembly cage for the R730 and R730xd chassis.
Manufacturer: DELL
-
R730xd 12B Flex Bay SAS Cable 08RJM1
This cable attaches the rear flex to the backplane (Port A2) on the R730xd 12 Bay chassis. This cable will NOT work with the 24 bay chassis. Due to differences in backplane design the 24 bay uses a different SAS cable. However, the signal and power cable remain the same.
-
R740xd x16 Half Riser 0RJRK7
This is the x16 half riser compatible with the R740xd chassis. It is typically used in tandem with a rear flex bay. Because the rear flex bay requires the removal of risers 2 and 3, the low profile half riser is able to sit beneath the flex bay for an additional x16 slot.
-
R730xd Flex Bay Signal Cable 0FD2FJ
This is a short signal cable that goes from the rear flex bay to the motherboard on the R730xd chassis.
-
R730xd Mid Bay Heatsink 0YYH68
These are heat sinks designed for the R730xd when the mid bay is installed. The mid bay doesn’t allow for the 2u heatsinks so these are used in their place. They are only recommended if you have the mid bay installed. They are too tall to work with the standard R730xd air shroud so pretty much useless unless you’re using the mid bay.