AKA Mr. Cold Boot

Archives: Parts

  • R530 Heatsink

    R530 Heatsink

    This is the heatsink for the Dell PowerEdge R530 server.

    Notes

    • The 08XH97 is a CPU heatsink for the Dell PowerEdge R530.
    • 08XH97 and 8XH97 are alternate representations of the same Dell part number.
    • It is a passive, screw-down heatsink designed for the R530’s Xeon E5-2600 v3/v4 processors.
    • Dell documentation/community information specifically identifies 08XH97 as the R530 heatsink.
  • R530 8 Bay LFF PERC Cable

    R530 8 Bay LFF PERC Cable

    This is the primary SAS storage cable for the Dell PowerEdge R530. It connects the backplane to a Dell compatible mini mono RAID controller.

    Notes

    • Connects the PERC controller to both SAS ports on the 8-drive backplane.
    • Uses two SFF-8087 Mini-SAS connectors at the backplane end.
    • Approximately 21.5 inches (0.55 m) long.
    • Intended for the R530 8 × 3.5-inch LFF configuration.
    • 0JCJNY and JCJNY are the same Dell part number, with the leading zero omitted in some listings.
  • R530 8 Bay LFF MB Signal Cable

    R530 8 Bay LFF MB Signal Cable

    This is the signal cable for the Dell PowerEdge R530 8 Bay LFF server. It connects the backplane to the motherboard.

    Notes

    • The 0PD7P8 is a 16-pin backplane signal cable used to connect the motherboard to the storage backplane.
    • It is documented for both the PowerEdge R520 and R530, including the 8-drive configurations.
    • The cable is approximately 12.5 inches (0.32 m) long.
    • 0PD7P8 and PD7P8 are the same Dell part number, with the leading zero omitted in many listings.
    • This is a signal/I²C cable, not the primary SAS data cable connecting the RAID controller to the drives. It carries communication between the system board and backplane.
    • The R530 uses this cable as part of the 8-bay backplane connection.
  • R530 8 Bay LFF Front Control Panel

    R530 8 Bay LFF Front Control Panel

    This is the front control panel for the Dell PowerEdge R530.

    Notes:

    • The 0CDVG8 is the front control panel assembly for the Dell PowerEdge R530.
    • The panel provides two USB 2.0 ports and one VGA port.
    • The assembly includes the power and NMI buttons and an LCD status display for system information, alerts, and diagnostic messages.
    • The associated cables are 00FTN6 and 0VCXFV.
    • This is the front control panel for the R530 8-LFF configuration in documented parts listings.
  • R530 Power Distribution Board

    R530 Power Distribution Board

    This is the main power distribution unit for the Dell PowerEdge R530. The unit interfaces with the power supplies and then feeds into the motherboard with multiple power cables.

    Notes:

    • The 012PJJ is the power distribution board used in the Dell PowerEdge R530 and T430. Dell itself identifies 12PJJ as the PDU/PDB part number.
    • It is designed for systems with two hot-swappable power supplies.
    • 012PJJ and 12PJJ are the same Dell part number, with the leading zero omitted in some listings.
    • The board handles distribution of power from the PSUs to the server’s internal power connections.
    • It is also commonly described as the power supply backplane or power supply distribution board.
    • R530 and T430 compatibility is well documented across Dell and parts references.

    Additional Photo(s):