This is the PERC Cable for the Dell PowerEdge R430 4 bay chassis. It also has 2 SATA connectors for the optional internal drive tray.
Part Category: RAID
-
R730xd 12B PERC Cable 08717G
This cable connects the backplane to one of Dells mini mono RAID controllers on the R730xd 12 Bay chassis.
Installation instructions
Plug one end into the backplane and then route the cable through the channel located on the right side of the server. The other end labeled PERC will terminate near the middle right side of the chassis. You will see the slot just before riser 1. Screw it down to a compatible DELL mini RAID controller.
-
Dell R740/R740xd Interposer 004M4C
This chip is known as an interposer. It’s essentially a bridge between the Mini Mono RAID controllers and the backplane. Without the interposer you are unable to install any of Dells mini RAID controllers. You can however install a regular PCIe card though. As I pointed out in this post, it limits you to a variation of riser 1 that has no x16 slot.
This is where you install the interposer. Installation instructions
Find the interposer slot located right in front of Riser 1. This is near the top right corner of the chassis. Match up the slot and press down until you hear the interposer snap into place.